Subject	retapping the plenum balance tube stud(s)..what sizes
Posted by	genic on July 08, 2007 at 6:51 PM
	This message has been viewed 160 times.
Message	my plenum balance tube stud(s) are a little stripped and i would like to retap them. what size would be the best? Any special precautions i should take while retapping them other than keeping the shavings out of of the plenum. anyone who has done this...any input would be greatly appreciated. also...did you replace the studs after you retapped the holes in the plenum? 06.05.2007 - 09:14 :: Imn0tSarcastic: I suck dick
Follow Ups	retapping the plenum balance tube stud(s)..what sizes - genic 18:51:36 07/08/07 I can't recall the size but coat the tap with grease to hold - Dave N 19:13:28 07/08/07 should be m8 @ 1.25 - spyhunterTT(nj) 19:45:33 07/08/07 LOL, I was way off. I'm glad you chimed in with the correct - Dave N 19:52:00 07/08/07 2nd did it the other day cause z1 sent me one - DaRealDefaulTT 20:40:10 07/08/07 shocking (n/m) - genic 22:32:30 07/08/07 If the holes arent completly stripped you could - EricTTZ 20:21:17 07/08/07 yea..the balance tube will be off the plenum - genic 20:52:19 07/08/07 You dont want to get a larger size tap. - EricTTZ 21:01:46 07/08/07 tks a lot...where did you pick up the helicoil tool from? (n/m) - genic 21:03:51 07/08/07 Autozone has them but i think advanced auto - EricTTZ 21:13:58 07/08/07 tks boss (n/m) - genic 22:30:56 07/08/07 thouse ALWAYS strip (n/m) - 300znick 01:44:16 07/09/07 hence why i need to RE-TAP THE DAMN THINGS! (n/m) - genic 17:31:05 07/09/07 One of my bolt holes was stripped so bad that I couldn't - Kelticttz 17:41:46 07/09/07
Post a Followup	You cannot reply to this message because you are not logged in.