TwinTurbo.NET: Nissan 300ZX forum - Re: How do you launch when running drag radials?
People Seeking Info
 
   


     
Subject Re: How do you launch when running drag radials?
     
Posted by orion on May 23, 2001 at 3:25 PM
  This message has been viewed 11 times.
     
In Reply To How do you launch when running drag radials? posted by rodelb on May 23, 2001 at 03:10 PM
     
Message I do a short burn out on BFG drag radials, I dont sit still but break so the car moves forward slowly while burning out, maybe 3-4 seconds total. I use launch control and dump the clutch at 4500rpm, thats usually just enought power to get a little screatch outa the tires then take off. On BFG's I run about 14psi and at that pressure I get very little wheel spin or hop.
Good luck,
John

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.