Subject	cut/drill/replace (n/m)
Posted by	mousersix on June 16, 2007 at 10:39 AM
	This message has been viewed 42 times.
In Reply To	FUNNY, im doing the same clutch job right now! uhh posted by Drk93TT on June 16, 2007 at 09:50 AM
Message
Follow Ups	New Clutch Bright and Early Tomorrow. - nonstopna 02:26:21 06/16/07 yes just be careful with the bearing sleeve.... - gt300zxtt 03:19:57 06/16/07 TOB is in the 3rd pic in the box - EricTTZ 03:37:14 06/16/07 lol, yes i see now that i am awake and sober (n/m) - gt300zxtt 09:30:09 06/16/07 naw got a new one, but thanks for making sure (n/m) - nonstopna 11:06:48 06/16/07 Lookin good... - Yourrid 08:16:32 06/16/07 2nd, but also wipe it again right before you put the - mousersix 10:38:51 06/16/07 Not replacing the front trans seal while it's out? - audioquest 08:35:08 06/16/07 Do NOT use the needle bearing for the pilot shaft. I just - Dave N 08:42:12 06/16/07 ^^^indeed^^^ - aliaZ 10:37:16 06/16/07 Yea I was kinda iffy about using it so I am going to stick - nonstopna 11:09:27 06/16/07 How about 3qt's of MT90 (n/m) - TTFairladyZ 08:57:09 06/16/07 FUNNY, im doing the same clutch job right now! uhh - Drk93TT 09:50:04 06/16/07 cut/drill/replace (n/m) - mousersix 10:39:56 06/16/07 cannot get in there do do any of the above - Drk93TT 10:42:11 06/16/07 geez.. - zleepertt(MD) 10:50:30 06/16/07 engine pull (n/m) - mousersix 16:19:16 06/16/07 Nice bro I just installed mine this weekend. (n/m) - DaRealDefaulTT 11:01:00 06/16/07 did you use PB Plaster? - aliaZ 11:02:40 06/16/07 When you felt it getting tight - TTFairladyZ 11:07:09 06/16/07 did. went back and forth in and out forever - Drk93TT 11:17:23 06/16/07 what kind of torch did you use? - aliaZ 11:35:19 06/16/07 Oxy-acetylene of course. the best. - Drk93TT 12:56:21 06/16/07 Well I will keep you guys posted on the progress with pics - nonstopna 11:12:32 06/16/07 Nice. I ordered the Max Street last night. - imney 15:16:26 06/16/07
Post a Followup	You cannot reply to this message because you are not logged in.