TwinTurbo.NET: Nissan 300ZX forum - 2nd, but also wipe it again right before you put the
Subject
2nd, but also wipe it again right before you put the
Posted by
mousersix
on June 16, 2007 at 10:38 AM
This message has been viewed
24
times.
In Reply To
Lookin good...
posted by Yourrid
on June 16, 2007 at 08:16 AM
Message
clutch disk on to remove any oily fingerprints you may have left
-Andrew
'90 Aztec Red NA > TT
Follow Ups
New Clutch Bright and Early Tomorrow.
-
nonstopna
02:26:21 06/16/07
yes just be careful with the bearing sleeve....
-
gt300zxtt
03:19:57 06/16/07
TOB is in the 3rd pic in the box
-
EricTTZ
03:37:14 06/16/07
lol, yes i see now that i am awake and sober (n/m)
-
gt300zxtt
09:30:09 06/16/07
naw got a new one, but thanks for making sure (n/m)
-
nonstopna
11:06:48 06/16/07
Lookin good...
-
Yourrid
08:16:32 06/16/07
2nd, but also wipe it again right before you put the -
mousersix
10:38:51 06/16/07
Not replacing the front trans seal while it's out?
-
audioquest
08:35:08 06/16/07
Do NOT use the needle bearing for the pilot shaft. I just
-
Dave N
08:42:12 06/16/07
^^^indeed^^^
-
aliaZ
10:37:16 06/16/07
Yea I was kinda iffy about using it so I am going to stick
-
nonstopna
11:09:27 06/16/07
How about 3qt's of MT90 (n/m)
-
TTFairladyZ
08:57:09 06/16/07
FUNNY, im doing the same clutch job right now! uhh
-
Drk93TT
09:50:04 06/16/07
cut/drill/replace (n/m)
-
mousersix
10:39:56 06/16/07
cannot get in there do do any of the above
-
Drk93TT
10:42:11 06/16/07
geez..
-
zleepertt(MD)
10:50:30 06/16/07
engine pull (n/m)
-
mousersix
16:19:16 06/16/07
Nice bro I just installed mine this weekend. (n/m)
-
DaRealDefaulTT
11:01:00 06/16/07
did you use PB Plaster?
-
aliaZ
11:02:40 06/16/07
When you felt it getting tight
-
TTFairladyZ
11:07:09 06/16/07
did. went back and forth in and out forever
-
Drk93TT
11:17:23 06/16/07
what kind of torch did you use?
-
aliaZ
11:35:19 06/16/07
Oxy-acetylene of course. the best.
-
Drk93TT
12:56:21 06/16/07
Well I will keep you guys posted on the progress with pics
-
nonstopna
11:12:32 06/16/07
Nice. I ordered the Max Street last night.
-
imney
15:16:26 06/16/07
Post a
Followup
You cannot reply to this message because you are not
logged in
.