Subject	Eric, I'll take it from here, thanks for promoting the TH400
Posted by	LitlElvis on May 20, 2007 at 2:10 PM
	This message has been viewed 111 times.
In Reply To	z324u alot of questions for you posted by stsgracing on May 19, 2007 at 10:40 PM
Message	Steve, The Specialty Z flexplate will work with the TH400 swap. A stock one will work too but I recommend Specialty Z's. Z1 has supplied my customers with driveshafts in the past. I have worked with PTC to build torque converters for this swap, they have my blueprint for dimensional specifications so you are gauranteed it will fit without hassles. Since I do not sell their converters, you are responsible for getting the right stall speed for your car. Shoot me an e-mail if you have any more questions.
Follow Ups	Best turbo set up for drag racing? - stsgracing 21:23:08 05/19/07 The biggest you can fit. (n/m) - zboost(NoVA) 21:28:21 05/19/07 my goal is not to make a high hp dyno queen with power out - stsgracing 21:33:20 05/19/07 It is all a trade off... - OrlandoTT 21:51:59 05/19/07 exactly, drag car = huge HP. (n/m) - zboost(NoVA) 21:53:25 05/19/07 I'm surprised, considering - RSR 08:10:52 05/20/07 don't you question him!!! - Spee 21:36:45 05/20/07 depends - z324u 21:56:28 05/19/07 what i was going to use is the Z1 built auto tranny with - stsgracing 22:09:45 05/19/07 sounds good to me. no experience with the nissan auto - z324u 22:16:02 05/19/07 what type of modifications were need to use the th400 trans? (n/m) - stsgracing 22:17:38 05/19/07 here - z324u 22:25:38 05/19/07 z324u alot of questions for you - stsgracing 22:40:58 05/19/07 Eric, I'll take it from here, thanks for promoting the TH400 - LitlElvis 14:10:07 05/20/07 Have you checked out the profiles on Z32racing.com? (n/m) - bbug 00:40:46 05/20/07 Remember... - Fuzznutz 01:28:44 05/20/07
Post a Followup	You cannot reply to this message because you are not logged in.