Subject	How convenient that you leave out the location
Posted by	AZHeat on May 18, 2007 at 7:31 PM
	This message has been viewed 53 times.
In Reply To	That only reinforces the point... posted by CaliguyPurdue (redesigning) on May 18, 2007 at 07:01 PM
Message	of the sensor in your post. The post is about downpipe not exhaust manifold. The uppper limit of DP egt is 1350, upper limit is 1550 in exhaust manifold. As an engineer you should know that the turbine section of turbo absorbs the heat energy, hence the downpipe temps are lower than before the turbine section. My egts measured in the exhaust manifold 850c -900 C measured 2 inches after the exhaust port on the back cylinders from my old set up. Not a "Gut Feeling" as you put it. "Yes, I know more then JWT. Someone has to be the top dog, and it just so happens it's me." Nixit
Follow Ups	Brazing cracked downpipes? - krazykyle 15:13:29 05/18/07 EGTs routinely get >1500F, so no. (n/m) - Joe(NoVA) 15:37:28 05/18/07 Not in the downpipe. (n/m) - AZHeat 15:45:14 05/18/07 "does anybody care what this guy thinks?" - Joe(NoVA) 16:23:02 05/18/07 Don't post erroneous info on EGTs in downpipe then you - AZHeat 17:19:01 05/18/07 LOL based on what?? Your gut feeling? (n/m) - CaliguyPurdue (redesigning) 18:14:40 05/18/07 My gut feeling tells me you are an ignorant asswipe - AZHeat 18:27:53 05/18/07 LOL. Nice source ;) - CaliguyPurdue (redesigning) 18:46:35 05/18/07 How about copy the entire source instead. - AZHeat 18:50:22 05/18/07 That only reinforces the point... - CaliguyPurdue (redesigning) 19:01:01 05/18/07 How convenient that you leave out the location - AZHeat 19:31:14 05/18/07 Either way, much higher than 1100°F so everyone STFU - BigTDogg (MA) 21:36:56 05/18/07 Exactly Thank you. (n/m) - AZHeat 22:08:06 05/18/07 I would weld it, making a single pass at a time and heat - Cap927(Boston) 15:43:17 05/18/07 2nd (n/m) - Joe(NoVA) 16:21:20 05/18/07
Post a Followup	You cannot reply to this message because you are not logged in.