Subject	Answers
Posted by	Russell@Z1 on May 15, 2007 at 3:59 PM
	This message has been viewed 93 times.
In Reply To	conversion posted by NA2TTZ on May 15, 2007 at 03:06 PM
Message	1. When doing a TT conversion we suggest upgrading your existing NA ECU with a Stage 3 TT Eprom (chip) and using your existing MAF (which is the same). 2. When we perform a TT Conversion there is a lot more than goes into it than just the used parts on a clip. Check out this link for some ideas. La-Z-Link 3. We run each clip and test them extensively after they have already been run and tested before shipping to the US by our suppliers. You won't find a more thoroughly checked Z32 clip anywhere. 4. Not sure I understand this one. I guess you'll just go pass like anyone else would as long as you have cats on and the car is assembled properly. You can still pass with downpipes. Russell Floyd Z1 Motorsports www.300zx.com 1990+ Nissan Z specialists Used Parts, New parts, Service/Repair and Performance 2877 Carrollton Villa Rica Hwy Carrollton, Ga 30116 770-838-7777 770-832-9253 (fax)
Follow Ups	conversion - NA2TTZ 15:06:49 05/15/07 ... - spyhunterTT(nj) 15:22:09 05/15/07 every clip I've seen included an ECU and MAF (n/m) - Guapo 15:33:57 05/15/07 i stand corrected then.. (n/m) - spyhunterTT(nj) 17:49:36 05/15/07 z1 and cox don't include them I don't think. No EFI either. (n/m) - Thebanman407 06:28:03 05/16/07 coz* my bad. (n/m) - Thebanman407 06:28:30 05/16/07 Some Answers... - AbsolutZ (OH) 15:31:12 05/15/07 Answers - Russell@Z1 15:59:17 05/15/07 More answers... - LoqueZX(CA) 16:08:25 05/15/07
Post a Followup	You cannot reply to this message because you are not logged in.