TwinTurbo.NET: Nissan 300ZX forum - The carbon tube is bonded to the joint
People Seeking Info
 
   


     
Subject The carbon tube is bonded to the joint
     
Posted by kuah@splparts.com on May 07, 2007 at 12:40 PM
  This message has been viewed 75 times.
     
In Reply To are the u joints pressed into the tube or what? posted by spyhunterTT(nj) on May 07, 2007 at 12:31 PM
     
Message using a very special glue (very top secret aerospace stuff apparently). We did not mark the driveshaft since we never suspected it, but we finally marked it after replacing everything else, that was when we realized the tube was clocking on the u-joint.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.