| has an analog wideband output wire. Setup is pretty simple: Strap the wideband analog output wire on the R500 into any available analog input on the Labjack. Also run a ground line from the R500's ground power line into the GND terminal closest to the analog input terminal you use. In the software, connect to the ZEM and click on the Data Acquisition Setup in the treeview menu on the left. Click the "NEW" button at the top right of that page. Enter a name for the input (WBO2 is fitting), use SINGLE type, select the AI channel number you connected the R500 to and leave the GAIN at default. In the scaling formula window, type in the following text:
v*2+10
and then click the UPDATE button at the top right. This will configure the channel, name it, and apply the scaling formula to convert the voltage signal to an actual wideband value. When you click on the real-time mode, at the bottom of the ZEM interface you will see the input channel, "WBO2" and the associated value in real-time. It also writes the information out to the datalog, which you can save each iteration of entering real-time mode by clicking the "Data Logging" drop-down menu and select "Save Current Datalog".
[ ashspecz.com ]
[ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving.
Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor.
Albert Einstein
|
