Subject	Please explain
Posted by	EricTTZ on May 02, 2007 at 12:28 AM
	This message has been viewed 218 times.
In Reply To	Re: Torque plate needed for re-build already in progress.... posted by Racerxmx on May 01, 2007 at 11:41 PM
Message	"What they found is the VG30DETT block is quite elastic, and the cylinder bores bowed about 1 to 1 1/2inchs down from the desk with the torque plate installed. " AIM: EricTTZ
Follow Ups	Torque plate needed for re-build already in progress.... - Drunkpunk082 21:37:50 05/01/07 if you're talking about an automatic flexplate - spyhunterTT(nj) 21:55:39 05/01/07 A torque plate is bolted to the block in place of a head - whitepearlz 22:06:11 05/01/07 I've never used one for my builds. Given how much metal - Ash's Z 22:30:52 05/01/07 That's pretty much what my machinist said. =) - whitepearlz 22:36:13 05/01/07 I agree. A waste of money . I had one custom made. (n/m) - AZHeat 22:37:55 05/01/07 sp500 reciept? (n/m) - Waco300zx(DFW) 01:01:54 05/02/07 Re: Torque plate needed for re-build already in progress.... - ouikikazz 22:54:10 05/01/07 not really necessary unless you're going for a huge - aliaZ 23:09:29 05/01/07 Re: Torque plate needed for re-build already in progress.... - Racerxmx 23:41:08 05/01/07 Please explain - EricTTZ 00:28:41 05/02/07 2nd.. I would not build any motor without it.. - Kong ZTT GT28RS MD 02:20:01 05/02/07 Where can I rent one? - Drunkpunk082 06:58:25 05/02/07 I cannot remember the name of the guy who - Kong ZTT GT28RS MD 23:37:26 05/02/07
Post a Followup	You cannot reply to this message because you are not logged in.