Subject	Try heating the UR at the center.
Posted by	PiotrC70 on April 16, 2007 at 12:28 AM
	This message has been viewed 29 times.
In Reply To	under drive pully posted by Nis300owner on April 15, 2007 at 11:52 PM
Message	During a friends install, the UR didn't seem to go on there and after taking a propane torch and consistently heating the center, (just enough to make it hot to the touch) it went on without problems. This being if the woodruff key is seated properly. Good luck.
Follow Ups	under drive pully - Nis300owner 23:52:57 04/15/07 To get a useful answer, you need to provide more info. - Dave N 00:00:31 04/16/07 Re: To get a useful answer, you need to provide more info. - Nis300owner 00:05:19 04/16/07 Will the UD pulley fit without the woodruff key in place? - Dave N 00:08:27 04/16/07 Re: Will the UD pulley fit without the woodruff key in place? - Nis300owner 00:12:18 04/16/07 Congrats. You now have officially the most screwed up - Guapo 00:15:52 04/16/07 What are you talking about the belt and stuff is fine all - Nis300owner 00:20:19 04/16/07 nothing. congrats on getting it together (n/m) - Guapo 00:26:13 04/16/07 Thanks It was an accomplishment only ever done basic - Nis300owner 00:28:32 04/16/07 wow... (n/m) - Waco300zx 00:31:52 04/16/07 A swing and a miss (n/m) - Broke_as_**** 00:55:47 04/16/07 clean out the slot the key goes in on the crank, and.... - Ghozt 00:21:56 04/16/07 Try heating the UR at the center. - PiotrC70 00:28:43 04/16/07 Thanks for the help guys! (n/m) - Nis300owner 00:30:00 04/16/07
Post a Followup	You cannot reply to this message because you are not logged in.