Subject	A little clarification....
Posted by	zeeway on April 15, 2007 at 5:38 PM
	This message has been viewed 176 times.
In Reply To	Re: Wouldn't think you would have to sweat that very posted by ouikikazz on April 15, 2007 at 05:31 PM
Message	The head is 14mm, the thread is 10MM by 1.5mm. Sorry for the misleading info. ____________________________________________________ The zeeway is for people who have never grown up. Count me in.
Follow Ups	engine stand bolt size - ouikikazz 15:48:33 04/15/07 Bring one of the tranny bolts with you to the hardware store - TTFairladyZ 15:58:27 04/15/07 Old head bolts work good. (n/m) - spddracer 16:13:48 04/15/07 * well (n/m) - Barry'z (NJ) 19:19:06 04/15/07 Deep subject. (n/m) - spddracer 20:22:53 04/15/07 Ashley is rubbing off on me ;~) (n/m) - Barry'z (NJ) 20:33:40 04/15/07 Dave just fainted (n/m) - Guapo 20:36:25 04/15/07 14 mm diameter by 1.5 mm thread pitch.... - zeeway 16:45:09 04/15/07 Re: 14 mm diameter by 1.5 mm thread pitch.... - ouikikazz 16:50:02 04/15/07 Wouldn't think you would have to sweat that very - zeeway 17:18:23 04/15/07 Re: Wouldn't think you would have to sweat that very - ouikikazz 17:31:18 04/15/07 A little clarification.... - zeeway 17:38:17 04/15/07
Post a Followup	You cannot reply to this message because you are not logged in.