Subject	Re: Wouldn't think you would have to sweat that very
Posted by	ouikikazz on April 15, 2007 at 5:31 PM
	This message has been viewed 138 times.
In Reply To	Wouldn't think you would have to sweat that very posted by zeeway on April 15, 2007 at 05:18 PM
Message	by any chance you know what size that would be in standard size? it seems the only metric bolt i find that size is a M10 with a 1.5 thread pitch... M14 is a 2.0 pitch...
Follow Ups	engine stand bolt size - ouikikazz 15:48:33 04/15/07 Bring one of the tranny bolts with you to the hardware store - TTFairladyZ 15:58:27 04/15/07 Old head bolts work good. (n/m) - spddracer 16:13:48 04/15/07 * well (n/m) - Barry'z (NJ) 19:19:06 04/15/07 Deep subject. (n/m) - spddracer 20:22:53 04/15/07 Ashley is rubbing off on me ;~) (n/m) - Barry'z (NJ) 20:33:40 04/15/07 Dave just fainted (n/m) - Guapo 20:36:25 04/15/07 14 mm diameter by 1.5 mm thread pitch.... - zeeway 16:45:09 04/15/07 Re: 14 mm diameter by 1.5 mm thread pitch.... - ouikikazz 16:50:02 04/15/07 Wouldn't think you would have to sweat that very - zeeway 17:18:23 04/15/07 Re: Wouldn't think you would have to sweat that very - ouikikazz 17:31:18 04/15/07 A little clarification.... - zeeway 17:38:17 04/15/07
Post a Followup	You cannot reply to this message because you are not logged in.