Subject	Re: Not on the inlet side
Posted by	Zenica on April 13, 2007 at 3:17 PM
	This message has been viewed 25 times.
In Reply To	Not on the inlet side posted by Broke_as_**** on April 13, 2007 at 03:07 PM
Message	So my leak, if I have one, is on the inlet side between the MAS and the turbos? After the incoming air charge is measured by the MAS so it dilutes the fuel causing a lean condition? I checked for a vacuum leak using carb spray. I figured if the idle changed then I found a leak but no matter where I shot a quick spray, no idle change.
Follow Ups	My Z is sick. - Zenica 13:53:55 04/13/07 50 psi is a bit low for full throttle - spyhunterTT(nj) 13:59:16 04/13/07 Re: 50 psi is a bit low for full throttle - Zenica 14:02:41 04/13/07 it is very easy, its on top of the plenum. like 2 10mm bolts - NobleZ 14:06:27 04/13/07 Your fuel pressure should be 43.5, at zero manifold - octavian-z 14:04:21 04/13/07 I forgot, also check your FPR (n/m) - octavian-z 14:06:34 04/13/07 correct, but will dip below that at idle, since - Guapo 14:09:28 04/13/07 Thanks for the replies.. - Zenica 14:12:47 04/13/07 RE: Idle psi - Broke_as_**** 14:19:24 04/13/07 It's an erratic jump because the fuel pump controller - octavian-z 14:26:21 04/13/07 With your mods, you should be around 375 rwhp. - eriksu9 14:25:04 04/13/07 Re: With your mods, you should be around 375 rwhp. - Zenica 14:32:47 04/13/07 that doesn't sound too far off - spyhunterTT(nj) 14:38:33 04/13/07 Re: that doesn't sound too far off - Zenica 14:41:48 04/13/07 A vacuum leak would cause him to run rich, not lean. (n/m) - Billteed1 15:00:52 04/13/07 I should have said a boost leak. - Billteed1 15:27:16 04/13/07 I would check for a vacuum leak after checking the FPR - olyar15 14:29:29 04/13/07 How would they let in unmetered air - Billteed1 15:02:38 04/13/07 Not on the inlet side - Broke_as_**** 15:07:42 04/13/07 Re: Not on the inlet side - Zenica 15:17:04 04/13/07 Carb sprary is good for find a leak... - Broke_as_**** 15:51:36 04/13/07 Re: Carb sprary is good for find a leak... - Zenica 16:00:27 04/13/07 I see - Billteed1 15:25:28 04/13/07
Post a Followup	You cannot reply to this message because you are not logged in.