Subject	Re: 50 psi is a bit low for full throttle
Posted by	Zenica on April 13, 2007 at 2:02 PM
	This message has been viewed 30 times.
In Reply To	50 psi is a bit low for full throttle posted by spyhunterTT(nj) on April 13, 2007 at 01:59 PM
Message	I have the boost controller set to 11 psi but depending on the weather, sometimes that setting is 10 to 12. How hard is it to replace the fuel pressure regulator? Does the rail/intake come off? I need an idea since I have a firm line of what I am capable of and not capable of.
Follow Ups	My Z is sick. - Zenica 13:53:55 04/13/07 50 psi is a bit low for full throttle - spyhunterTT(nj) 13:59:16 04/13/07 Re: 50 psi is a bit low for full throttle - Zenica 14:02:41 04/13/07 it is very easy, its on top of the plenum. like 2 10mm bolts - NobleZ 14:06:27 04/13/07 Your fuel pressure should be 43.5, at zero manifold - octavian-z 14:04:21 04/13/07 I forgot, also check your FPR (n/m) - octavian-z 14:06:34 04/13/07 correct, but will dip below that at idle, since - Guapo 14:09:28 04/13/07 Thanks for the replies.. - Zenica 14:12:47 04/13/07 RE: Idle psi - Broke_as_**** 14:19:24 04/13/07 It's an erratic jump because the fuel pump controller - octavian-z 14:26:21 04/13/07 With your mods, you should be around 375 rwhp. - eriksu9 14:25:04 04/13/07 Re: With your mods, you should be around 375 rwhp. - Zenica 14:32:47 04/13/07 that doesn't sound too far off - spyhunterTT(nj) 14:38:33 04/13/07 Re: that doesn't sound too far off - Zenica 14:41:48 04/13/07 A vacuum leak would cause him to run rich, not lean. (n/m) - Billteed1 15:00:52 04/13/07 I should have said a boost leak. - Billteed1 15:27:16 04/13/07 I would check for a vacuum leak after checking the FPR - olyar15 14:29:29 04/13/07 How would they let in unmetered air - Billteed1 15:02:38 04/13/07 Not on the inlet side - Broke_as_**** 15:07:42 04/13/07 Re: Not on the inlet side - Zenica 15:17:04 04/13/07 Carb sprary is good for find a leak... - Broke_as_**** 15:51:36 04/13/07 Re: Carb sprary is good for find a leak... - Zenica 16:00:27 04/13/07 I see - Billteed1 15:25:28 04/13/07
Post a Followup	You cannot reply to this message because you are not logged in.