| Attach housings with hoses already attached to front bumper. Then, after installing front bumper, go through the turn signal hole (with light out obviously) and stuff the hose in the IC ducts which you should have already cut holes in. be sure to make sure the hose just barley fits in the duct so it won't hinder flow from the main opeing. Then dab a little bit of silicone gasket sealer on the hose and outside of the IC ducts so you will hold them in place but still alow for easy removal when taking the bumper off in the future.
Thanks,
Mike
1991 Black Twin Turbo La-Z-Link
^^Hard engine break in method^^
La-Z-Link
^^My Myspace^^ 
---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that
"felt wierd fingering my exhuast for 1hr with no results :(" - zboost
"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z "I think I'll pass on giving my car a handjob" - joel(PA) "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21 |
