TwinTurbo.NET: Nissan 300ZX forum - I actually wanted the resistance of the 90 degree turn...
People Seeking Info
 
   


     
Subject I actually wanted the resistance of the 90 degree turn...
     
Posted by The_S_Man (Phoenix) on March 08, 2007 at 11:20 PM
  This message has been viewed 241 times.
     
In Reply To looks like the air has to make an abrupt turn. Not good posted by Guapo on March 08, 2007 at 04:27 PM
     
Message I want the resistance of the turn in the pipe to make sure that the balance between the two banks of the engine would be identical....

I verified this with two Innovate LM-1 Wideband O2 sensors. They are spot on. Here's a pdf of a third gear street pull that I did two weeks ago with this intake installed:

[ http://www.users.qwest.net/~jamie_esperson/ttNet/overlay.pdf ]

And here was the dyno I did a couple days earlier with this dual intake installed:

[ http://www.twinturbo.net/net/viewmsg.aspx?forum=general&msg_id=1953162 ]

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.