TwinTurbo.NET: Nissan 300ZX forum - FSM has a thing about runout I didn't have a guage but...
People Seeking Info
 
   


     
Subject FSM has a thing about runout I didn't have a guage but...
     
Posted by Zownr4life on March 01, 2007 at 2:12 PM
  This message has been viewed 84 times.
     
In Reply To can someone explain why clocking my driveshaft 1/4 turn posted by ZEngineer on March 01, 2007 at 01:41 PM
     
Message Clocking totally works. My center carrier went out and I went down to COZ

[shameless plug COZ is the man]

and got a Z1 1-piece platinum, shifter support bracket, bushings, and CZP short throw shifter. Got everything installed took her out for a run much improved until I got to about 70 then the vibration was there but not in the center of the car it was now at the diff. Put her back on the jackstands clocked it to the third position from initial {2+2 only 4 positions} instead of the 2nd drove it and still had the vibes. Took it back to the 2nd positon from initial and the thing is like glass no vibes at all.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.