Subject	It would me easy to make an oil separator with
Posted by	AzHeat on February 19, 2007 at 2:45 PM
	This message has been viewed 54 times.
In Reply To	I'm sure you know, but so no one is mislead its Stainless posted by maglito on February 19, 2007 at 01:12 PM
Message	SS souring pads and cylinder shaped can with hose barbs on opposite sides. Put the SS scouring pads inside the can. By having the hose barbs on opposite sides, the air had to flow through the pads. You can open the can and clean the scouring pad with solvent or replace it with new scouring pads when they get all gucky.
Follow Ups	New PCV reroute is posted in Technical. - Woody75 (Denver) 08:30:06 02/19/07 well done :) (n/m) - Guapo 08:35:50 02/19/07 Tim, is your email in profile correct? - spicyZ 08:48:16 02/19/07 Yes, it's correct. - Woody75 (Denver) 08:54:44 02/19/07 Email sent to this alternate account.. (n/m) - spicyZ 08:59:03 02/19/07 I also couldn't email you. (n/m) - gimpmobz 11:05:22 02/19/07 very nice (n/m) - collegeboy 09:12:35 02/19/07 Thanks, very nice! (n/m) - PiranhaTT 09:31:52 02/19/07 Thanks! (n/m) - TheTwinZ (Peru) 09:59:50 02/19/07 ... - dvlhntr 11:20:11 02/19/07 I got that too... (n/m) - collegeboy 12:57:47 02/19/07 You Win!! The ultimate PCV reroute write-up. has been put in (n/m) - boileralum 11:35:35 02/19/07 Thank you, very helpful with pictures :) (n/m) - Slobo7x 12:02:00 02/19/07 Good Job!! The only issue I see is the there is no air/oil - AzHeat 12:06:53 02/19/07 As I stated in the post, I don't feel the pads are needed - Woody75 (Denver) 12:43:37 02/19/07 I'm sure you know, but so no one is mislead its Stainless - maglito 13:12:48 02/19/07 It would me easy to make an oil separator with - AzHeat 14:45:35 02/19/07
Post a Followup	You cannot reply to this message because you are not logged in.