Subject	for the timing belt
Posted by	spyhunterTT(nj) on February 17, 2007 at 3:40 PM
	This message has been viewed 47 times.
In Reply To	where do i find FSM referenced tools? posted by beaZTT on February 17, 2007 at 03:20 PM
Message	there is another way to do it. Follow the instructions in the fsm. I believe you measure the gap of the auto tensioner arm. Should be 3.5 to 5.0 mm, 4mm recommended, after rotating it several times and then waiting 10 minutes. The tensioner adjustment bolts should be roughly right in the middle of it's side to side movement Alex
Follow Ups	where do i find FSM referenced tools? - beaZTT 15:20:48 02/17/07 for the timing belt - spyhunterTT(nj) 15:40:38 02/17/07 I think they are Kentmoore (n/m) - YugoBernie (NoVA) 15:41:20 02/17/07 Or OTC (n/m) - spddracer 16:01:03 02/17/07
Post a Followup	You cannot reply to this message because you are not logged in.