TwinTurbo.NET: Nissan 300ZX forum - addendum >>
People Seeking Info
 
   


     
Subject addendum >>
     
Posted by ztunerz on February 15, 2007 at 7:35 PM
  This message has been viewed 351 times.
     
In Reply To your 1st point>>> posted by ztunerz on February 15, 2007 at 07:22 PM
     
Message If what you are saying is correct why do 4 1.5 inch tubes on a typical 8cly header terminate into a 3 or 3.5 inch collector. If exhaust pulses follow each other but don't add up like you say, we would have a collector that was around 1.5 inches. I think you need to revisit your theory again. Collector size and design is CRITICAL in how a header/manifold flows overall. Thats why testing the collector would provide valuable data. Individual runner flow is no good unless you match it with a equally well flowing collector

my 2 cents

Harry

Formerly yellowzxtt

" If it doesn't make it faster, i don't care "
Please visit www.ztuner.com to GO FASTER

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.