Subject	I think your right...
Posted by	pilotgod404 on February 12, 2007 at 2:39 AM
	This message has been viewed 40 times.
In Reply To	Wait a sec.... posted by Twainsville on February 12, 2007 at 01:32 AM
Message	When i calculated it out i got each runner being 3.013sqin, or 2.77" in dia. but only 1 runner (2 valves) are in use at any given time... There for the intake piping (and end tanks of the plenum) would need to be 2 7/8" (Or 3"). Makes sense now.
Follow Ups	*confused* about intake design... - pilotgod404 23:11:51 02/11/07 Forced induction usually helps offet negative impact. (n/m) - FantasyZ 23:44:57 02/11/07 No - collegeboy 23:45:21 02/11/07 that makes a little more sense.. thanks (n/m) - pilotgod404 23:52:40 02/11/07 Yea you made a common mistake - collegeboy 23:55:18 02/11/07 i did actually calculate area... but i got the number mixed - pilotgod404 23:56:38 02/11/07 Really? - collegeboy 00:08:36 02/12/07 Wait a sec.... - Twainsville 01:32:32 02/12/07 I think your right... - pilotgod404 02:39:59 02/12/07 No (n/m) - collegeboy 10:23:34 02/12/07 Ah ok..didn't think..if only one runner is open at a time... - collegeboy 10:22:40 02/12/07 Well I'm assuming only one is open at a time... - Twainsville 10:50:37 02/12/07
Post a Followup	You cannot reply to this message because you are not logged in.