Subject	Very nice, I vote move to tech and FAQ. (n/m)
Posted by	jmw23712 on January 25, 2007 at 12:26 AM
	This message has been viewed 108 times.
In Reply To	DIY homemade degree wheel to check cam timing posted by AzHeat on January 25, 2007 at 12:13 AM
Message
Follow Ups	DIY homemade degree wheel to check cam timing - AzHeat 00:13:03 01/25/07 Very nice, I vote move to tech and FAQ. (n/m) - jmw23712 00:26:38 01/25/07 Ditto, very good information. (n/m) - zweebach 10:11:09 01/25/07 Nice! You don't see that often. (n/m) - BradZ (Go Gators!) 00:29:21 01/25/07 Very nice work! Good information to know (n/m) - Booster (MD) 11:31:04 01/25/07
Post a Followup	You cannot reply to this message because you are not logged in.