Subject	The only reason to use non-OEM HG is if you are
Posted by	AzHeat on January 17, 2007 at 12:28 PM
	This message has been viewed 71 times.
In Reply To	So whats the consensus on Cometic multi-layer steel HG? posted by BooZted on January 17, 2007 at 12:16 PM
Message	using much larger than stock pistons to the point that the OEM is too small. The OEM HG as pretty strong. I haven't seen the Cometics. Do they have silicon sealant around the water and oil hole area? If they do then you are fine. My old JUN metal HG did not and they leaked oil on one side. It was seeping out on one corner of the head.
Follow Ups	So whats the consensus on Cometic multi-layer steel HG? - BooZted 12:16:48 01/17/07 The only reason to use non-OEM HG is if you are - AzHeat 12:28:38 01/17/07 They have a bead formed into them that allows them to - BooZted 12:30:12 01/17/07 My JUN HG have the same bead so do the Tomei. - AzHeat 12:34:51 01/17/07 THE KEY to getting MLS gaskets to seal is to get - ztunerz 13:48:54 01/17/07
Post a Followup	You cannot reply to this message because you are not logged in.