Subject	Interesting point, I didn't consider the fact that the
Posted by	LitlElvis on January 15, 2007 at 8:15 AM
	This message has been viewed 32 times.
In Reply To	Agreed the removal of the casting flashing will >>> posted by ZUL8TR on January 15, 2007 at 07:47 AM
Message	injectors are not timed with the valve events. But this is bordering on theoretical ramifications that I'm not able to test. In any event I'm certain that the surface finish is not as smooth as an Extrude Hone job would be.
Follow Ups	Extrude honed plenums... Bah!!!! - LitlElvis 20:44:50 01/13/07 Nice work. (n/m) - Barry'z (NJ) 21:07:09 01/13/07 2nd. if i could weld that well, i'd do it to one of my spare - spyhunterTT(nj) 10:57:21 01/14/07 Good welding :D - xAzraelx 21:12:47 01/13/07 Nice (n/m) - Eishozzzz 22:03:56 01/13/07 I think you should have left the holes - bankruptedz 22:53:03 01/13/07 crap!.. I coulda mounted extra throttle bodies there :-) - LitlElvis 22:59:30 01/13/07 Nice! (n/m) - BradZ (Go Gators!) 23:57:41 01/13/07 nice (n/m) - aliaZ 01:17:16 01/14/07 good job but why didn't yyou just cut the plenum in half - Antonio(AZ) 03:22:44 01/14/07 Not a half bad idea but alignment of the halves>> - ZUL8TR 06:00:10 01/14/07 It's the KISS principle, that would be a lot of extra work - LitlElvis 13:57:59 01/14/07 Would have been nice to have a B4&after air flow test. >> - ZUL8TR 06:06:08 01/14/07 Thanks, but the injectors are downstream from>>> - LitlElvis 13:52:34 01/14/07 Agreed the removal of the casting flashing will >>> - ZUL8TR 07:47:48 01/15/07 Interesting point, I didn't consider the fact that the - LitlElvis 08:15:34 01/15/07 Thats interesting. Nice work,. (n/m) - Chris(NJ) 06:51:28 01/14/07 Nice piece. (n/m) - Turnerscasa (Dallas) 07:17:02 01/14/07 Neato. (n/m) - RSR 07:41:42 01/14/07 Great idea and nice work! (n/m) - Boosted1 08:57:46 01/14/07 dude, now that is cool. (n/m) - Mikeys300zx 11:01:07 01/14/07 Like a stack of dimes - very nice! (n/m) - TT XTZ 14:40:56 01/14/07 Great job! (n/m) - TheTwinZ (Peru) 20:19:29 01/14/07
Post a Followup	You cannot reply to this message because you are not logged in.