Subject	crap!.. I coulda mounted extra throttle bodies there :-)
Posted by	LitlElvis on January 13, 2007 at 10:59 PM
	This message has been viewed 48 times.
In Reply To	I think you should have left the holes posted by bankruptedz on January 13, 2007 at 10:53 PM
Message	actually, my first plan was to weld a full length flange with a bolt on/off cover on each side for future access, but somewhere along the line I got lazy.
Follow Ups	Extrude honed plenums... Bah!!!! - LitlElvis 20:44:50 01/13/07 Nice work. (n/m) - Barry'z (NJ) 21:07:09 01/13/07 2nd. if i could weld that well, i'd do it to one of my spare - spyhunterTT(nj) 10:57:21 01/14/07 Good welding :D - xAzraelx 21:12:47 01/13/07 Nice (n/m) - Eishozzzz 22:03:56 01/13/07 I think you should have left the holes - bankruptedz 22:53:03 01/13/07 crap!.. I coulda mounted extra throttle bodies there :-) - LitlElvis 22:59:30 01/13/07 Nice! (n/m) - BradZ (Go Gators!) 23:57:41 01/13/07 nice (n/m) - aliaZ 01:17:16 01/14/07 good job but why didn't yyou just cut the plenum in half - Antonio(AZ) 03:22:44 01/14/07 Not a half bad idea but alignment of the halves>> - ZUL8TR 06:00:10 01/14/07 It's the KISS principle, that would be a lot of extra work - LitlElvis 13:57:59 01/14/07 Would have been nice to have a B4&after air flow test. >> - ZUL8TR 06:06:08 01/14/07 Thanks, but the injectors are downstream from>>> - LitlElvis 13:52:34 01/14/07 Agreed the removal of the casting flashing will >>> - ZUL8TR 07:47:48 01/15/07 Interesting point, I didn't consider the fact that the - LitlElvis 08:15:34 01/15/07 Thats interesting. Nice work,. (n/m) - Chris(NJ) 06:51:28 01/14/07 Nice piece. (n/m) - Turnerscasa (Dallas) 07:17:02 01/14/07 Neato. (n/m) - RSR 07:41:42 01/14/07 Great idea and nice work! (n/m) - Boosted1 08:57:46 01/14/07 dude, now that is cool. (n/m) - Mikeys300zx 11:01:07 01/14/07 Like a stack of dimes - very nice! (n/m) - TT XTZ 14:40:56 01/14/07 Great job! (n/m) - TheTwinZ (Peru) 20:19:29 01/14/07
Post a Followup	You cannot reply to this message because you are not logged in.