Subject	I have one.
Posted by	xybertron on December 25, 2006 at 7:24 PM
	This message has been viewed 68 times.
In Reply To	Who has an OS Giken Twin Disk clutch in there Z posted by natottz on December 24, 2006 at 08:24 PM
Message	It holds fine but has a little chatter. Mostly when I have it out of gear with the clutch in. If I let the clutch out the noise stops. Leaving from a stop is rougher than the JWT single street which held the power as well (just couldn't launch at all) but not nearly as harsh as a 6 puck. Install is pretty easy just make sure you get the right TOB and an alignment tool.
Follow Ups	Who has an OS Giken Twin Disk clutch in there Z - natottz 20:24:06 12/24/06 I would just buy a RPS... (n/m) - Eishozzzz 22:19:25 12/24/06 ats destroys just about any clucth out there besides tilton - Antonio(AZ) 23:09:38 12/24/06 Is the ATS a good streetable clutch? - Kong ZTT GT28RS MD 03:05:40 12/25/06 Re: Is the ATS a good streetable clutch? - jochen 05:28:37 12/25/06 mine is all carbon. I have the new carbonetics ats. - Antonio(AZ) 13:23:31 12/25/06 What's the difference between that and the RPS? - zboost_ 16:49:35 12/25/06 Clutches dont hold HP, they hold torque. (n/m) - spddracer 09:08:31 12/25/06 I just wanted to make sure the OS twin disk - natottz 09:22:44 12/25/06 Re: I just wanted to make sure the OS twin disk - jochen 10:13:22 12/25/06 I don't drive the car everyday. - natottz 10:33:31 12/25/06 Re: I don't drive the car everyday. - MikeC(NZ) 15:41:57 12/25/06 I have one. - xybertron 19:24:21 12/25/06 which to bearing do i needed (n/m) - natottz 20:15:06 12/25/06
Post a Followup	You cannot reply to this message because you are not logged in.