Subject	Getting new Front Control Arms, what else?
Posted by	Zepolcire on December 13, 2006 at 10:27 AM
	This message has been viewed 98 times.
Message	My front left one is done for, so going to get some replacements (either Powertrix or SPL). I have been reading in posts that it is a good idea to also get the tension rods to prevent bearing wear, and might as well do the steering rack bushings. I have a question about the tension rods. Looking at images of the SPL/Powertrix ones, are the ends a urethane or just powder coated black? Just comparing them to the Nismo ones which are polished all over (and $100 more). Powertrix Tension Rods Nismo Tension Rods And as long as I am budgeting for this stuff, anything else I should do while this is being done? Thanks for the advice! Zep
Follow Ups	Getting new Front Control Arms, what else? - Zepolcire 10:27:20 12/13/06 Don't see how/why the ends would be urethane... - mbrock15 10:47:28 12/13/06 The tension rods you mentioned are all pillow ball style - YugoBernie (NoVA) 10:54:17 12/13/06 The black section is a rubber dirt/dust boot. (n/m) - Woody75 (Denver) 10:56:07 12/13/06 Powertrix or SPL FTW!! - MixManMash 11:06:36 12/13/06 Just got tensions rods from SPL installed yesterday - ben7021 12:08:37 12/13/06 I second that. (n/m) - sfarrah 13:43:37 12/13/06 Id get SPL over PowerTrix. - twinturbopoweredz 15:52:04 12/13/06
Post a Followup	You cannot reply to this message because you are not logged in.