Subject	They should be the same according to service manual. (n/m)
Posted by	AzHeat on December 04, 2006 at 7:59 PM
	This message has been viewed 31 times.
In Reply To	Question concerning Manual vs. Auto cams posted by TTFairladyZ on December 04, 2006 at 06:30 PM
Message
Follow Ups	Question concerning Manual vs. Auto cams - TTFairladyZ 18:30:32 12/04/06 no (n/m) - aliaZ 18:34:15 12/04/06 I have a a/t ttz swapped to a 5-spd - I've run up against - Whiteghoztt (MD) 18:54:19 12/04/06 Ditto, My car is a rocket at 3000 rpm - spddracer 19:39:44 12/04/06 They should be the same according to service manual. (n/m) - AzHeat 19:59:13 12/04/06 They have different part numbers. They are not the same. (n/m) - YugoBernie (NoVA) 22:11:27 12/04/06 What is the actual specs? (n/m) - AzHeat 23:16:33 12/04/06 Re: What is the actual specs? - aliaZ 23:44:46 12/04/06 Re: What is the actual specs? - spddracer 06:24:16 12/05/06 it's fine for stock turbos - turbomaniac 20:50:26 12/04/06 When i swapped out my motor with the JDM motor... - The-FActor 20:51:55 12/04/06 I actually swapped out the cams in my auto JDM motor - S.Watson (Savannah, GA) 21:11:29 12/04/06 i asked a similar question about auto cams the other day - upcominZ_(NOLA) 22:26:31 12/04/06 Re: i asked a similar question about auto cams the other day - aliaZ 23:06:34 12/04/06 why would there be a hp loss b/c of the smaller turbine - upcominZ_(NOLA) 00:22:04 12/05/06 Re: why would there be a hp loss b/c of the smaller turbine - aliaZ 00:34:29 12/05/06
Post a Followup	You cannot reply to this message because you are not logged in.