Subject	Next Spring I will try this after reading your post>>
Posted by	Spectrum (WI) on December 02, 2006 at 1:12 PM
	This message has been viewed 49 times.
In Reply To	It sounds like you have the Snow WI Kit. If that is the posted by The Devils Z on December 02, 2006 at 05:14 AM
Message	1) Readjust the water injection pump back to full pressure. 2) For my particular setup (20psi max boost) if I want to effectivly reduce the amount of water going in the engine I should set the max pressure pot on the variable controller greater than 20 psi. If I understand this correctly the controller is basically varies the voltage going to the pump so if I set it to a value higher than my current boost setting the pump will never reach its max capable pressure.
Follow Ups	Some observations while tunning The Water Injection - Spectrum (WI) 00:44:30 12/02/06 did you have the 220psi pump? what's your low+hi setting - 23rulz 01:47:23 12/02/06 It sounds like you have the Snow WI Kit. If that is the - The Devils Z 05:14:47 12/02/06 Yo Eric! Are you coming to ATCO this morning or are you - phillyz 06:48:41 12/02/06 I think you missed - SactoTodd 09:30:04 12/02/06 well Eric must be here somewhere. - Spee 16:37:23 12/02/06 Yeah I'll be there this morning (n/m) - ERIC. 17:00:51 12/02/06 Next Spring I will try this after reading your post>> - Spectrum (WI) 13:12:46 12/02/06 I would suggest using a smaller nozzle, but maybe you - The Devils Z 19:05:02 12/02/06 Maybe someone should do write up on tuning a WI using - AzHeat 15:04:15 12/02/06 good idea, as long as it's not you or Dee. (n/m) - Spee 16:14:21 12/02/06 Speenis pokes his head out like a turtle to take a snap (n/m) - AzHeat 18:37:48 12/02/06 The basic set up / install is the same .. for tuning in - The Devils Z 19:10:14 12/02/06 Re: It sounds like you have the Snow WI Kit. If that is the - ni[X]it 20:21:16 12/02/06 *lbs (n/m) - Spee 16:13:16 12/02/06 you didnt buy the Accumulator? You need to. - ni[X]it 20:19:08 12/02/06 My opinon about the accumulator is it would have to be.. - Spectrum (WI) 13:24:32 12/03/06
Post a Followup	You cannot reply to this message because you are not logged in.