Subject	how about measuring the air temp in the plenum
Posted by	ZEngineer on December 01, 2006 at 7:44 AM
	This message has been viewed 49 times.
In Reply To	We picked up an analog input module for our dyno last week. posted by Russell@Z1 on November 30, 2006 at 09:02 PM
Message	by inserting a probe through one of the many boost signal holes? Immediately before & after the IC is a good measuring location, but also consider that air exiting the IC still has to travel through hot pipes, so what matters most is which IC delivers the coolest air to the plenum. Do you agree? _________________________________________________________________________________ Im n0t Sarcastic (Kenny): not to over do it, but you're certainly the source of high-class Z mods ZEngineer24: what do you mean by that? Im n0t Sarcastic: I just mean, your Z is one I really admire "The Z is the cause and the solution to all my problems" -- Me "If your car was my car, I'd think it's broken"
Follow Ups	We picked up an analog input module for our dyno last week. - Russell@Z1 21:02:18 11/30/06 Why no ducts? (n/m) - Broke_as_**** 21:15:08 11/30/06 Re: Why no ducts? - Russell@Z1 21:22:02 11/30/06 Russell, did you get my mail? - TheTwinZ (Peru) 21:48:33 11/30/06 No, what address did you send it to? (n/m) - Russell@Z1 21:53:46 11/30/06 info@300zx.com - TheTwinZ (Peru) 21:55:14 11/30/06 I don't get those, unless you put it to my attention only. - Russell@Z1 22:01:36 11/30/06 YGM! I emailed you this afternoon... - TheTwinZ (Peru) 22:17:08 11/30/06 don't know of any good probes, but maybe a tip - turbomaniac 22:44:56 11/30/06 Building your own amps brings up a million tech issues... - CaliguyPurdue 02:09:46 12/01/06 See if the unit accepts thermocouple input or has amplified - CaliguyPurdue 02:05:23 12/01/06 2nd on type k (n/m) - BigTDogg (MA) 09:06:15 12/01/06 how about measuring the air temp in the plenum - ZEngineer 07:44:39 12/01/06 Russell - GM AIT temp sensor Or the AEM AIT - ztunerz 09:35:54 12/01/06 i did a science project on intake charge temps.. - Nixta TTZ 10:02:03 12/01/06
Post a Followup	You cannot reply to this message because you are not logged in.