Subject	Re: Why no ducts?
Posted by	Russell@Z1 on November 30, 2006 at 9:22 PM
	This message has been viewed 49 times.
In Reply To	Why no ducts? (n/m) posted by Broke_as_**** on November 30, 2006 at 09:15 PM
Message	Just for speeding the process up changing everything out between runs. We are blowing basically same amount of air across the face of each unit from equal distances with "squirrel cage" blowers. As long as we are doing all the tests the same way, I don't feel the ducts are needed for our purposes of comparing heat exchange and flow characteristics. They might actually complicate the comparisons. Russell Floyd Z1 Motorsports www.300zx.com 1990+ Nissan Z specialists Used Parts, New parts, Service/Repair and Performance 2877 Carrollton Villa Rica Hwy Carrollton, Ga 30116 770-838-7777 770-832-9253 (fax)
Follow Ups	We picked up an analog input module for our dyno last week. - Russell@Z1 21:02:18 11/30/06 Why no ducts? (n/m) - Broke_as_**** 21:15:08 11/30/06 Re: Why no ducts? - Russell@Z1 21:22:02 11/30/06 Russell, did you get my mail? - TheTwinZ (Peru) 21:48:33 11/30/06 No, what address did you send it to? (n/m) - Russell@Z1 21:53:46 11/30/06 info@300zx.com - TheTwinZ (Peru) 21:55:14 11/30/06 I don't get those, unless you put it to my attention only. - Russell@Z1 22:01:36 11/30/06 YGM! I emailed you this afternoon... - TheTwinZ (Peru) 22:17:08 11/30/06 don't know of any good probes, but maybe a tip - turbomaniac 22:44:56 11/30/06 Building your own amps brings up a million tech issues... - CaliguyPurdue 02:09:46 12/01/06 See if the unit accepts thermocouple input or has amplified - CaliguyPurdue 02:05:23 12/01/06 2nd on type k (n/m) - BigTDogg (MA) 09:06:15 12/01/06 how about measuring the air temp in the plenum - ZEngineer 07:44:39 12/01/06 Russell - GM AIT temp sensor Or the AEM AIT - ztunerz 09:35:54 12/01/06 i did a science project on intake charge temps.. - Nixta TTZ 10:02:03 12/01/06
Post a Followup	You cannot reply to this message because you are not logged in.