Subject	Re: Did you read Kyle's post below? Even so, read it again.
Posted by	jas0n3485 on November 21, 2006 at 12:51 PM
	This message has been viewed 33 times.
In Reply To	Did you read Kyle's post below? Even so, read it again. (n/m) posted by Inzane on November 21, 2006 at 12:30 PM
Message	I just dont want any bent valves in the future, thats why i asked.
Follow Ups	So am I missing anything on the engine rebuild. - jas0n3485 22:54:53 11/20/06 probably find the oil squirters on classifieds. - yosha 22:58:54 11/20/06 Re: probably find the oil squirters on classifieds. - jas0n3485 23:00:57 11/20/06 Re: Re: probably find the oil squirters on classifieds. - jas0n3485 23:03:38 11/20/06 i think if u invest this much money into your engine.. - yosha 23:07:24 11/20/06 stock rods can handle plenty of power.. - Kong ZTT GT28RS MD 01:07:12 11/21/06 Here's a couple - Agner.S(CT) 23:08:11 11/20/06 Re: Here's a couple - jas0n3485 23:24:21 11/20/06 Re: So am I missing anything on the engine rebuild. - boostedzxtt (SoOk) 23:29:35 11/20/06 Re: Re: So am I missing anything on the engine rebuild. - jas0n3485 23:37:56 11/20/06 From reading the above posts, why wouldn't a built engine - dregos 00:31:14 11/21/06 A few things - Kyle(Houston) 07:06:52 11/21/06 The "mild cams" are a waste of money on a TT. Even JWT - Inzane 10:30:05 11/21/06 I spoke to Ben yesterday about their cams, he gave - AzHeat 11:17:27 11/21/06 Are stock valves good enought - jas0n3485 12:11:44 11/21/06 Did you read Kyle's post below? Even so, read it again. (n/m) - Inzane 12:30:00 11/21/06 Re: Did you read Kyle's post below? Even so, read it again. - jas0n3485 12:51:15 11/21/06 So be sure to get a new timing belt, problem solved (n/m) - BigTDogg (MA) 12:57:57 11/21/06 Re: I spoke to Ben yesterday about their cams, he gave - MannyB 18:03:45 11/21/06 "400" or "400+"? (n/m) - Inzane 18:15:58 11/21/06 why did he recommend stock springs??? (n/m) - aliaZ 22:14:21 11/21/06 Stock springs will work good with the JWT 400 cams. - lewoolf2 00:27:07 11/22/06
Post a Followup	You cannot reply to this message because you are not logged in.