and so far not very impressed with the amount of mods i needed to do to get them to bolt on. 1) clock housings to correct angles 2) my oil drain lines did not line up properly so had to bend them a bit 3) i was unable to get the LHS compressor outlet pipe on even with the "adapter" supplied so had to weld up a 30mm length of straight alloy to the adapter and use a 90degree silicon elbow to connect the compressor outlet pipe to. 4) the LHS oil feed line had no means of being attached to the outlet where the oil pressure sender is mounted so had to fabricate a new fitting 5) have to re-sync the actuators as the rods were altered after clocking the housings
20:51:00 11/15/06
