TwinTurbo.NET: Nissan 300ZX forum - I have stock cams....one of the few things that was'nt
Subject
I have stock cams....one of the few things that was'nt
Posted by
racer2fst
on November 11, 2006 at 11:46 PM
This message has been viewed
20
times.
In Reply To
do you have cams? you may have overlap!!! (n/m)
posted by octavian-z
on November 11, 2006 at 11:06 PM
Message
replaced.
Rob D.
Follow Ups
why is built engine has lower compression???
-
hawaii2z
21:26:44 11/11/06
pending milage, the rings my not be fully seated yet.
-
SpecNATT (Houston)
21:34:12 11/11/06
Also, it could be from the piston design. Ash did my motor
-
racer2fst
21:53:39 11/11/06
122-127, seems kinda low, but then again i dunno much abuot
-
Eishozzzz
22:48:47 11/11/06
I had my engine done by SGP winter/spring 2004
-
RHulme
22:53:59 11/11/06
my old SGP engine w/ wisecos did 150-160 psi after 12k mi (n/m)
-
SpecNATT (Houston)
23:31:02 11/11/06
do you have cams? you may have overlap!!! (n/m)
-
octavian-z
23:06:43 11/11/06
I have stock cams....one of the few things that was'nt -
racer2fst
23:46:07 11/11/06
yea with my stock cams I'm in the 176-178psi range for my TT (n/m)
-
SkiFly01
01:57:10 11/12/06
Mine are JWT 400 cams and springs, (n/m)
-
RHulme
23:53:43 11/11/06
with cams you will see a little less compression...
-
octavian-z
00:33:10 11/12/06
I have never seen the test turned over @"full throttle" ... (n/m)
-
The Devils Z
06:32:33 11/12/06
susposed to do it with throttle open on all cars or on the
-
SpecNATT (Houston)
10:20:27 11/12/06
gotcha .. .balance tube is always off (n/m)
-
The Devils Z
17:50:42 11/12/06
Test was done with balance tube off,
-
RHulme
11:57:58 11/12/06
My original motor from SGP was consistently around
-
The Devils Z
06:31:08 11/12/06
also keep in mind...
-
tyler@boostpro.net
20:41:24 11/12/06
Post a
Followup
You cannot reply to this message because you are not
logged in
.