Subject	Well
Posted by	94BlackFairladyZ on November 09, 2006 at 10:32 PM
	This message has been viewed 31 times.
In Reply To	Hard pipes posted by Zski on November 09, 2006 at 10:19 PM
Message	I've actually heard to use hair spray, slides when wet and dries quickly to form a strong bond between the metal and silicon/rubber. Which was tested on a Audi S4 TT running 30psi of boost...without any leaks or pipes popping off
Follow Ups	Hard pipes - Zski 22:19:00 11/09/06 spray with WD40 to let connectors slide. Slide connectors - mpbond(STL) 22:27:40 11/09/06 2nd (n/m) - RHulme 22:32:10 11/09/06 Well - 94BlackFairladyZ 22:32:01 11/09/06 I don't rec'd that b/c a lot of times you need to readjust - Scotts94z32 16:06:07 11/10/06 I use hairspray each and every time I remove my ic pipes - dogpile 18:09:41 11/10/06 Windex (n/m) - ZonaZ 22:34:25 11/09/06 2nd - Dallas DamonZ 23:21:43 11/09/06 it's the main reason I went with the stillen - moxie 23:34:25 11/09/06 nevermind that hardpipes are gay (n/m) - Guapo 23:36:50 11/09/06 well, naturally (n/m) - moxie 23:40:39 11/09/06 i think being gay might be genetic (n/m) - Zeorymer (Albany) 23:53:30 11/09/06 If that's the case, then hellooooo thailor! (n/m) - Scotts94z32 16:06:54 11/10/06 yup (n/m) - Zeorymer (Albany) 23:53:52 11/09/06 If you dont feel comfortable with spraying WD40 - Kong ZTT GT28R MD 22:58:17 11/09/06 2nd alittle WD goes along way.... (n/m) - Booster (MD) 23:47:51 11/09/06 use petroleum jelly (n/m) - RedSER13 23:09:28 11/09/06 Did you try installing them first? It's pretty - Dustin 00:05:36 11/10/06 Seriously... - Cincyzx 00:15:05 11/10/06 Apparantly enough for manufacturors to put directions on - Di Lo 01:15:14 11/10/06 haha that's the truth - jaku 01:39:58 11/10/06 Thanks man - Cincyzx 01:52:28 11/10/06 Re: Seriously... - thejones (Sacto, CA) 11:18:41 11/10/06 The windex in the shade is easiest, but the heat can't hurt - Scotts94z32 16:08:18 11/10/06 Flavored water based lube (n/m) - BigTDogg (MA) 10:02:55 11/10/06 2nd. - CatnipZ 11:24:09 11/10/06
Post a Followup	You cannot reply to this message because you are not logged in.