Subject	My final drag race at infineon raceway.
Posted by	Zerosum on November 03, 2006 at 6:39 PM
	This message has been viewed 241 times.
Message	Great overcast conditions, low track temps, and ambient air temps in the low 60's. Testing out the new MT drag radials with great anticipation. First run an 11.8 @121 w/ 1.77 60. Not bad but i could have done better. Second run prepare the two step @ 4k with 10psi.......launch..........snap. Pass. side axle goes. After searching on TT.net I am confused as to what I should do. Naturally i would switch over to a tt subframe with leader gears but i would have to change the one piece driveshaft and deal with the hicas delete on the TT subframe itself. Not having a TT chassis I am confused as to what unforseen difficulties may arise during the course of this improvment. By the way tt axles wont fit an NA diff for what reason? Anyone found anyone who makes NA axles that are cryo/shotpeened? Any help is much appriciated.
Follow Ups	My final drag race at infineon raceway. - Zerosum 18:39:11 11/03/06 Marty @ Raxles might have some beefy axles for us NA guys - Crim 18:56:43 11/03/06 I should say us TT guys w/ NA rear ends ;) (n/m) - Crim 18:57:10 11/03/06 Re: I should say us TT guys w/ NA rear ends ;) - Overkill 20:44:52 11/03/06 TT axles wont fit, cuz they are thicker and i believe they - Eishozzzz 06:09:11 11/04/06 He's right. - Ballistic 11:35:34 11/04/06 I have seen a vid of a supra that was launching with a - LJZTT 13:10:50 11/04/06
Post a Followup	You cannot reply to this message because you are not logged in.