Subject	You are over looking the amperage draw not just
Posted by	AzHeat on November 01, 2006 at 1:17 PM
	This message has been viewed 90 times.
In Reply To	I will look into that tonight to if the AEm has variable posted by natottz on November 01, 2006 at 12:27 PM
Message	voltage. I doubt the AEM is designed for the amperage load of a fuel pump. The only think you want to use the AEM is to trigger a relay. But you can use a pressure sensitive switch for that that cost under $20.
Follow Ups	AEM EMS question.. - Kong ZTT GT28R MD 02:22:35 11/01/06 Given that most people have never even heard of what an FPC - TTFairladyZ 07:18:02 11/01/06 STI's also have them, they are more popular than you think - Slow3z 10:21:41 11/01/06 if you have the correct setup to hold - natottz 10:31:00 11/01/06 to run Dual fuel pumps.. you need two FPCs.. - Kong ZTT GT28R MD 10:45:41 11/01/06 Or you can just hardwire ONE pump into the power line - Kong ZTT GT28R MD 11:42:43 11/01/06 It's been a while since I messed with the FPC system - DAYTONAZ 18:22:59 11/01/06 There two ways you can hook up the pumps on an AEM. - natottz 08:02:03 11/01/06 yea for real.. - Kong ZTT GT28R MD 10:48:12 11/01/06 You would not want to use the FPC anyways.... - BOOZTD 3 08:30:01 11/01/06 You can spice in a second stock fuel pump controller unit - natottz 10:32:43 11/01/06 that is what Ash tried to do with Dee's Z.. - Kong ZTT GT28R MD 10:49:33 11/01/06 I'm at 9441 miles now running two Walbro 255L/hr HP pumps - Ash's Z 11:44:01 11/01/06 Odd how it works out - BOOZTD 3 12:13:22 11/01/06 I connected the two pumps' wires to the terminals on - Ash's Z 12:19:54 11/01/06 Just want to make sure i under stand this correctly. - natottz 12:21:04 11/01/06 Both pumps are wired togheter at the bulkhead terminals - Ash's Z 13:01:41 11/01/06 Thank You! I will have to try that out! - natottz 13:04:49 11/01/06 I've never played with the AEM, but I would presume that - Ash's Z 11:49:51 11/01/06 so if I didn't get the AEM now/?? - Kong ZTT GT28R MD 12:04:41 11/01/06 I you want an extra FPC and the harness that connect to it. - natottz 12:08:05 11/01/06 I will look into that tonight to if the AEm has variable - natottz 12:27:59 11/01/06 You are over looking the amperage draw not just - AzHeat 13:17:48 11/01/06 Yur right AEm setup just triggers a Relay. - natottz 14:26:06 11/01/06 AEM actually makes a FPC unit. (n/m) - AzHeat 13:15:33 11/01/06 This site offer a fuel pump controller. - AzHeat 13:38:07 11/01/06
Post a Followup	You cannot reply to this message because you are not logged in.