TwinTurbo.NET: Nissan 300ZX forum - Re: Is the Conzult or Blatz compatible with the AEM?
People Seeking Info
 
   


     
Subject Re: Is the Conzult or Blatz compatible with the AEM?
     
Posted by zboost(tx) on October 30, 2006 at 2:51 PM
  This message has been viewed 129 times.
     
In Reply To Is the Conzult or Blatz compatible with the AEM? posted by Kong ZTT GT28R MD on October 30, 2006 at 02:45 PM
     
Message Here's where you set-up what you are using. I beilieve the MAP (if you use map and ditch the MAF) plugs into the existing MAF wiring.



BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :)
stock turbos/injectors


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.