Subject	I have the Michelin but even it requires driving up on 2x6
Posted by	doug8867 on October 21, 2006 at 6:04 PM
	This message has been viewed 33 times.
In Reply To	Are there ANY jacks out there that are low enough? posted by KaneZ on October 21, 2006 at 02:25 PM
Message	It is a good jack however, much better than the Craftsman I had which surprising was a pos.
Follow Ups	Question for the Canadians - KaneZ 11:39:56 10/21/06 The problem with most of the CT jacks is that they are not a - MixManMash 12:55:21 10/21/06 I use that brand and the matching jack stands.... - Chad M (CeeLo) 13:02:52 10/21/06 Re: Question for the Canadians - pcproa 13:14:19 10/21/06 that's not low enough for the Z - ZEngineer 13:31:12 10/21/06 Oh man don't get me started on CT sales.... - Chad M (CeeLo) 13:34:21 10/21/06 yep, hard to resist when they put stuff at 50% off - KaneZ 14:20:34 10/21/06 Are there ANY jacks out there that are low enough? - KaneZ 14:25:03 10/21/06 Not that I've seen. I have the AC Hydraulics DK13HLQ - olyar15 15:19:40 10/21/06 I have the Michelin but even it requires driving up on 2x6 - doug8867 18:04:33 10/21/06 Our jacks read in metric, so they go lower :) - vorpalZ 16:47:17 10/21/06
Post a Followup	You cannot reply to this message because you are not logged in.