TwinTurbo.NET: Nissan 300ZX forum - I love mine. Installation was a little tricky but after
People Seeking Info
 
   


     
Subject I love mine. Installation was a little tricky but after
     
Posted by Riddick (looks clear) on October 10, 2006 at 7:27 PM
  This message has been viewed 62 times.
     
In Reply To greddy profec e-01 ebc... posted by Dragon_300TTZ on October 10, 2006 at 05:22 PM
     
Message all is said and done I wouldn't switch.

The auto mode sucks and boost response is really sucky. You have to set it up in manual mode. From your profile I see you are running stock turbo's.

What boost do you want to run?

for 14 lbs of boost set it up like this;

Set 50
Gain 20
Start Boost 12

This should give you a good base to start with. If you want less boost, back off the set in incriments of 5. Make sure the start boost is around 2 or 2.2 lbs less than achievable boost ie, 15lbs set your start boost at 12.8 to 13. I do not recommend playing with the gain. 20 is optimum. Leave it there and forget about it.

The gain setting is very crucial. You can play around in incraments of .2 if you like but in the end you will stay at 20 most likely. This is perfect for a set of stock turbo's.

Hope this helps. Anything else let me know. I like the anti stall feature for BOV venting. Tough to dial in but definately worth it.

P.S I recommend starting off with incraments of 5 on the set until you reach 50. This way you can be sure it was set up properly without worry of engine damage due to faulty installation.

Good luck.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.