Subject	i've experienced this as well.
Posted by	apudapus on October 10, 2006 at 11:24 AM
	This message has been viewed 52 times.
In Reply To	BlaZt cable question posted by vorpalZ on October 10, 2006 at 08:36 AM
Message	it appears there's an issue with the receiving end of the cable because sending data out works (try turning on the auxiliary fan with the free conzult software). with the homemade DDLs, you can change one of the resistors to make it work with different years. rough technical explanation: there isn't enough of a swing on the incoming data bits. therefore you change a pull-up (or was it pull-down?) resistor. here's an old discussion of it on the Nissan ECU Tuning forum http://ecu2.forumwise.com/ecu2-thread1278.html *********************************
Follow Ups	BlaZt cable question - vorpalZ 08:36:24 10/10/06 I've heard of inconsistant results w. some ECUs. - YugoBernie (NoVA) 10:03:57 10/10/06 Just looking at the BlaZt product website they sure mention - Inzane 10:41:31 10/10/06 i've experienced this as well. - apudapus 11:24:30 10/10/06 I have a USB BlaZt cable and the 1.4 Datascan. I've yet to - 240Z FeO2 11:51:06 10/10/06 Long story short, the usb cable has been redesigned. I - whatsthegoodword 12:14:24 10/10/06 Cool. I purchased the cable from you on the group buy - MixManMash 13:50:18 10/10/06
Post a Followup	You cannot reply to this message because you are not logged in.