Subject	thanks, just wasn't sure if it's ok to run an 89mm on stock
Posted by	zboost(tx) on October 09, 2006 at 2:58 PM
	This message has been viewed 27 times.
In Reply To	He used the 89 mm. Running fine. (n/m) posted by NitroPow on October 09, 2006 at 01:20 PM
Message	shortblock. How's his engine holding up? He's the one who made 600+rwhp on stock motor right? done any compression#'s after the dyno? BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Thats how a 1350whp 300ZX engine sounds like. - NitroPow 13:11:33 10/09/06 Question your brother Z>>> - zboost(tx) 13:17:54 10/09/06 He used the 89 mm. Running fine. (n/m) - NitroPow 13:20:04 10/09/06 Or it could be the 90.5. (n/m) - NitroPow 13:26:04 10/09/06 thanks, just wasn't sure if it's ok to run an 89mm on stock - zboost(tx) 14:58:23 10/09/06 690rwhp. Engine is strong - NitroPow 00:45:30 10/10/06 Wow...Very nice! Too bad is not mounted on a 300ZX. (n/m) - TheTwinZ (Peru) 13:31:02 10/09/06 Ours will be. ;) (n/m) - NitroPow 13:40:23 10/09/06 That's the right way to do it :) (n/m) - TheTwinZ (Peru) 15:31:57 10/09/06 can you host it on YouTube or streetfire so every can see it (n/m) - WAGGZ 13:42:45 10/09/06 2nd (n/m) - Kong ZTT GT28R MD 14:58:51 10/09/06 3rded (n/m) - blacksc 16:16:46 10/09/06 4rd (n/m) - ENVYMYZ 18:40:36 10/09/06 what was it in? (n/m) - SpecNATT (Houston) 19:44:43 10/09/06
Post a Followup	You cannot reply to this message because you are not logged in.