Subject	we use something similar on our assembly line at Peterbilt
Posted by	aliaZ on October 06, 2006 at 12:46 PM
	This message has been viewed 92 times.
In Reply To	Refilling coolant system......new tool. posted by Chad M (CeeLo) on October 06, 2006 at 11:35 AM
Message	MUCH bigger of course, but same concept
Follow Ups	Refilling coolant system......new tool. - Chad M (CeeLo) 11:35:00 10/06/06 I have one rented from autozone I'll let you know - CaliguyPurdue 11:41:51 10/06/06 Did you finally solve your overheating problem Chad? (n/m) - Inzane 11:44:02 10/06/06 Re: Did you finally solve your overheating problem Chad? - Chad M (CeeLo) 12:07:21 10/06/06 We use one, makes bleeding the coolant system alot quicker. - Robert@Z1 11:52:15 10/06/06 Bleed the cooling system? - BigTDogg (MA) 12:15:17 10/06/06 BTW, I wasn't being condescending, asking fo reelz (n/m) - BigTDogg (MA) 12:49:02 10/06/06 That is what I was talking about, bleeding air pockets from - Robert@Z1 13:16:21 10/06/06 Ah, ok, thanks for the follow up. (n/m) - BigTDogg (MA) 13:18:21 10/06/06 Just have to make sure all your liquid silicone gasket has - Russell@Z1 13:52:12 10/06/06 It's been two months, I hope it's cured by now!! :0 - BigTDogg (MA) 13:57:04 10/06/06 It cures enough in just a few hours. - Russell@Z1 14:36:27 10/06/06 we use something similar on our assembly line at Peterbilt - aliaZ 12:46:19 10/06/06 That tool is the shiznit (n/m) - Spddracer 18:21:18 10/06/06 Just used it.....worked like a charm :-) - Chad M (CeeLo) 20:52:16 10/06/06 I have the snap-on, all it uses is the rubber adaptors - Spddracer 08:58:59 10/07/06
Post a Followup	You cannot reply to this message because you are not logged in.