Subject	Refilling coolant system......new tool.
Posted by	Chad M (CeeLo) on October 06, 2006 at 11:35 AM
	This message has been viewed 969 times.
Message	Does anyone have experience using a tool like this too refill the coolant system? It basically uses a compressor to vacuum all the air out of the cooling system and then replaces it with coolant. It says to bring the vacuum level to 25 inches of mercury, from what I can find that is about -12 psi Just wondering if anyone has had any bad experiences with something like thi? ------------------------------------------------------------ 1995 300ZX TT
Follow Ups	Refilling coolant system......new tool. - Chad M (CeeLo) 11:35:00 10/06/06 I have one rented from autozone I'll let you know - CaliguyPurdue 11:41:51 10/06/06 Did you finally solve your overheating problem Chad? (n/m) - Inzane 11:44:02 10/06/06 Re: Did you finally solve your overheating problem Chad? - Chad M (CeeLo) 12:07:21 10/06/06 We use one, makes bleeding the coolant system alot quicker. - Robert@Z1 11:52:15 10/06/06 Bleed the cooling system? - BigTDogg (MA) 12:15:17 10/06/06 BTW, I wasn't being condescending, asking fo reelz (n/m) - BigTDogg (MA) 12:49:02 10/06/06 That is what I was talking about, bleeding air pockets from - Robert@Z1 13:16:21 10/06/06 Ah, ok, thanks for the follow up. (n/m) - BigTDogg (MA) 13:18:21 10/06/06 Just have to make sure all your liquid silicone gasket has - Russell@Z1 13:52:12 10/06/06 It's been two months, I hope it's cured by now!! :0 - BigTDogg (MA) 13:57:04 10/06/06 It cures enough in just a few hours. - Russell@Z1 14:36:27 10/06/06 we use something similar on our assembly line at Peterbilt - aliaZ 12:46:19 10/06/06 That tool is the shiznit (n/m) - Spddracer 18:21:18 10/06/06 Just used it.....worked like a charm :-) - Chad M (CeeLo) 20:52:16 10/06/06 I have the snap-on, all it uses is the rubber adaptors - Spddracer 08:58:59 10/07/06
Post a Followup	You cannot reply to this message because you are not logged in.