TwinTurbo.NET: Nissan 300ZX forum - let me rephrase that
People Seeking Info
 
   


     
Subject let me rephrase that
     
Posted by scubasteve (rebuilding) on September 29, 2006 at 10:36 AM
  This message has been viewed 48 times.
     
In Reply To LOL (n/m) posted by BigTDogg (MA) on September 29, 2006 at 10:06 AM
     
Message CarlZX posted pics of bent rods, but that was because the NA wrist pin broke, the rod seperated from the piston, and the crank would then cram the rod into (or through) the block. point is, from the factory, the first thing to go is usually the rod bearings or ring lands.

--.scubasteve.--


(Rebuild started: April 2004. estimated completion: sigh)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.