Subject	Wouldn't it be wise to buy some dust boots then?
Posted by	zboost(tx) on September 27, 2006 at 9:45 PM
	This message has been viewed 60 times.
In Reply To	Well after the shock in my SPL coilover went bad.... posted by Patrick(Austin) on September 27, 2006 at 09:40 PM
Message	I don't know you would keep the pistons clean with no boots..... unless it's a garage queen :p BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Well after the shock in my SPL coilover went bad.... - Patrick(Austin) 21:40:18 09/27/06 Wouldn't it be wise to buy some dust boots then? - zboost(tx) 21:45:26 09/27/06 because I would have to get the shocks all pulled out. - Patrick(Austin) 21:51:35 09/27/06 It will cost you way more in the long run... but, whatever - zboost(tx) 22:01:06 09/27/06 Ill look into it. (n/m) - Patrick(Austin) 22:08:05 09/27/06 Easy way to put boots on would be to buy 2 sets and - SlicktopTT 12:14:21 09/28/06 They will continue to fail IMHO if you don't get boots. (n/m) - YugoBernie (NoVA) 22:44:20 09/27/06 Mine has no boots - kuah@splparts.com 23:13:12 09/27/06 Typically miles not time is what matters, but either way its - YugoBernie (NoVA) 23:29:47 09/27/06 Mine has more than 20-30k mi - kuah@splparts.com 00:08:20 09/28/06 Listen Patrick, $hit happens. Manufactures mess up, parts - Eishozzzz 05:04:54 09/28/06 I think you replied to the wrong person... (n/m) - jmoore010 10:34:14 09/28/06 Thanks. (n/m) - YugoBernie (NoVA) 08:49:20 09/28/06 Thanks kuah for the help very much appreciated. =) (n/m) - Patrick(Austin) 06:36:13 09/28/06
Post a Followup	You cannot reply to this message because you are not logged in.