Subject	Here>>>
Posted by	zboost(tx) on September 26, 2006 at 8:31 AM
	This message has been viewed 39 times.
In Reply To	Do you happen to know what tool to use to take the ... posted by skateguy92 on September 25, 2006 at 09:26 PM
Message	You need a tamper proof T-50 "star" (what I call them) to remove the airbag, then a 17mm for the actual wheel, and finally a steering wheel remover tool to pop out the steering wheel. BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	importsextreme group buy - twintz1991 21:13:47 09/25/06 Do you happen to know what tool to use to take the ... - skateguy92 21:26:30 09/25/06 i will find out tommorow (n/m) - twintz1991 21:34:23 09/25/06 Here>>> - zboost(tx) 08:31:56 09/26/06 Wheel looks cheaply done! - bankruptedz 21:49:14 09/25/06 Why do you say that - all the edges are covered by the - YugoBernie (NoVA) 23:57:46 09/25/06 yah the red stitch came out kinda bad - twintz1991 00:44:00 09/26/06 Care to expand on your statement? - aspendog 11:29:16 09/26/06 no worries, dirty hands will darken that red stich:) (n/m) - volcomstone550 23:46:08 09/25/06 My red stitch wheel is not done that way. My wheel - TT-Z 08:28:11 09/26/06 I stand corrected. That is the way it is on IE website. (n/m) - TT-Z 08:34:17 09/26/06 It is a '99 JSPEC Replica w/ the perf grips & square stitch - aspendog 11:26:20 09/26/06 yah im not bashing it - twintz1991 13:54:40 09/26/06 How much did the wheel cost you? (n/m) - Shawn300zTT GT28R MD 11:16:01 09/26/06
Post a Followup	You cannot reply to this message because you are not logged in.