Subject	WI pump question (mounting)
Posted by	Rickytl (ma) on September 20, 2006 at 5:16 PM
	This message has been viewed 68 times.
Message	i think the easiest way to set up my WI (snow performance will be to use the stock washer reservoir in the trunk as the source of water/meth but i was wondering if anyone using the Snow Performance pump from the GB was doing this also, and if so do you mount it near the reservoir or closer/in the engine bay. the reason i ask is that Dave N and i were concerned that the lose of water pressure from the extra tubing to go to the rear of the car would affect the output of the pump to my engine. thnx for all the help guys *****Disclaimer - My spelling is horrific! i appologise in advance :)****** -RickyTL (MA)-
Follow Ups	WI pump question (mounting) - Rickytl (ma) 17:16:45 09/20/06 Why would you do that? (n/m) - Izzy 17:29:18 09/20/06 do what? - Rickytl (ma) 17:48:12 09/20/06 Used front mount reservoir - Izzy 19:35:02 09/20/06 Whats wrong with using the rear mounted reservoir? - TTFairladyZ 20:45:34 09/20/06 The problem is, where do you mount the pump as the pump must - MixManMash 09:41:27 09/21/06 This is a '92 NA (now TT'd) that we're working on - no front - Dave N 16:45:33 09/21/06 even if we did the tank would be higher than the pump (n/m) - Rickytl (ma) 21:20:52 09/21/06 Mount the pump so that the inlet/outlet is at the bottom. - pieboy100 15:01:30 09/21/06
Post a Followup	You cannot reply to this message because you are not logged in.