TwinTurbo.NET: Nissan 300ZX forum - You need to fix your camber issues before you drop your car
People Seeking Info
 
   


     
Subject You need to fix your camber issues before you drop your car
     
Posted by sfpearl300zTT on September 15, 2006 at 11:03 AM
  This message has been viewed 164 times.
     
In Reply To about to drop posted by supersayianjim on September 15, 2006 at 10:27 AM
     
Message Get some front adjustable camber arms to go along with the rear ones and the tension rods, get and alignment, and if that resolves your camber issues causing the tire wear, THEN think about dropping it further.

Never modify a car with known issues.

If you want a 1.8inch drop front and rear, expect something like this:

Its not exactly the most comfortable ride, and you most definately will have to watch the roads you ride on, but the handling difference is worth it to me.

------------------------------------------------------------


bJammmin: i was thinking about masking off the bottom part (black on your lip) and painting mine flat black, caus it'll just keep getting scuffed forever
sfpearl300z: thats half the reason why i did it to mine
sfpearl300z: dont have to worry about any imperfections
sfpearl300z: cause it gets so much abuse
bJammmin: yeah dude so true goddamn
bJammmin: why are you a fucking genius
sfpearl300z: lol
sfpearl300z: you know what i hate?
bJammmin: whats dat yo
sfpearl300z: being so damn smart
bJammmin: LOL


sfpearl300z: i actually dont look too far into the lives of people on the forums
sfpearl300z: dont pay close enough attention
WickedPuddle: see
WickedPuddle: thats where you and i are different
WickedPuddle: i am on a whole different level of having no life


MiCHaeLkiH: i forked out 650 for my vibrating one


Fst300zx: its never been a problem until lately HAHA
sfpearl300z: lol
Fst300zx: itll fall everyonce ina while.. i just pump it a few times and it stays up
sfpearl300z: yeah
Fst300zx: haha damn this is a rough conversation

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.